Influence of preheating on residual stresses in ultra-high strength steel welded components
Jiamin Sun, Klaus Dilger
Abstract
Preheating is generally required in the welding of ultra-high strength steels (UHSSs) for avoiding cold cracking. The present work systematically explores the influence of preheating on welding residual stresses (WRS) in components made of UHSS by means of both experiments and numerical simulations. The results reveal that, no matter what UHSS is with or without metallurgical phase transformation, preheating has a great influence on the magnitude of transverse residual stress (σT-RS). In general, the higher preheating temperature (TPH) the lower magnitude of σT-RS is. Preheating would change the longitudinal residual stress (σL-RS) sign in the weld area and σL-RS amount obviously diminishes with the increase of TPH for transforming UHSS, while that has nearly no influence on the maximum σL-RS but has an impact on the area of tensile σL-RS for non-transforming UHSS. The effect of entire preheating and partial preheating on WRS in UHSS welded components could be nearly the same. Nevertheless, TPH in the partial preheating case (about 300 °C here) should be higher than that in the entire preheating one (corresponding 100 °C here) for that same effect. The weld dimensions, especially the size of the heat-affected zone (HAZ), and cooling time Δt8/5 significantly increase with TPH. Preheating has almost no influence on the restraint degree of welded components.