A 0.7–5.7 GHz Reconfigurable MIMO Receiver Architecture for Analog Spatial Notch Filtering Using Orthogonal Beamforming
Sajad Golabighezelahmad, Eric A.M. Klumperink, Bram Nauta
Abstract
A highly reconfigurable direct-conversion software-defined multiple-input multiple-output (MIMO) receiver with four RF inputs and four I/Q baseband outputs is proposed. It allows for digital MIMO but also analog interference rejection by spatial notch filtering through four flexible and simultaneous orthogonal beams. A segmented constant-Gm vector modulator (VM) with improved interference tolerance and wide RF frequency range targeting the sub-6-GHz bands is proposed. It exploits current-domain beamforming before I- V conversion by transimpedance amplifiers. A 0.7-5.7-GHz 22-nm fully depleted silicon-on-insulator (FD-SOI) prototype chip achieves >29 dB spatial filtering for a single notch and an ultrawideband 20-dB notch suppression bandwidth of 2.3 GHz at broadside excitation at an local oscillator (LO) frequency of 2.5 GHz. In the notches, an IIP3 of +16 dBm and B1dB of -11.5 dBm at a 41-dB gain is achieved, improving IIP3 and B1dB by 35 and 27 dB, respectively, by spatial filtering. A single-element noise figure (NF) of 5.5-7 dB is achieved on the VM constellation corners, degrading about 2 dB on the points nearby the biggest circle fitting into a square constellation. However, sub-3-dB system NF is potentially achievable, taking into account up to 6-dB improvement by the four-element beamforming. Given both gain and phase control provided by the VM, spatial patterns with up to three independent nulls can be synthesized with the four-element antenna array. The chip of 0.52 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> active area consumes 77-139 mW at an LO-frequency of 0.7-5.7 GHz from a 0.8-V supply.