Pool boiling heat transfer of ammonia outside a single tube with fin structures: Hysteresis phenomena and boiling enhancement
Jin Sub Kim, Wookyoung Kim, Hak Soo Kim, Young Kim, Seok Ho Yoon
Abstract
Pool boiling heat transfer of ammonia outside a single tube was investigated at three saturation pressures of 6.15, 8.57, and 11.7 bar (saturation temperature of 10, 20, and 30 °C) at the heat fluxes ranging from 1.2 to 72.9 kW/m2. Hysteresis in a boiling curve and boiling enhancement were examined on both the smooth tube with machined roughness and two enhanced tubes with low fins and re-entrant cavities. All three tubes have outermost diameters from 15.68 to 15.87 mm and the same length of 796 mm. A large hysteresis between increasing the heat flux and decreasing the heat flux was observed on the smooth tube, and the hysteresis increased as the saturation pressure decreased. The boiling hysteresis of ammonia was reasonably explained from the thermodynamic analysis based on Clausius-Clapeyron and Young-Laplace equations. Heat transfer coefficients on the enhanced tubes were increased by 47% to 105% (Low-fin) and 103% to 159% (Turbo-E) compared with the smooth tube at the saturation pressure of 8.57 bar. However, the hysteresis itself was increased on the enhanced tubes owing to the wall temperature decrease along the fin. Hydrophobic coating and the enhanced tube having re-entrant cavities with cavity mouths of a few micrometers were suggested to mitigate the hysteresis phenomena in the pool boiling of ammonia.