Redox Couples Control Band Bending, Photovoltage, and Quasi-Fermi Levels in Tungsten Oxide (WO<sub>3</sub>) Photoanodes
Li Wang, Frank E. Osterloh
Abstract
Tungsten oxide (WO 3 ) is a well-known photoanode and photocatalyst for photoelectrochemical (PEC) water oxidation. Because the compound has a deep valence band, it can facilitate the oxygen evolution reaction without added cocatalysts, and it can drive the oxidation of species with much higher electrochemical potentials, including the conversion of water to hydrogen peroxide, sulfate to persulfate, and iodate to meta-periodate. Here, we use the liquid vibrating Kelvin probe surface photovoltage (liquid VK-SPV) technique in combination with open circuit potential (OCP) and photoelectrochemical (PEC) scans to assess the possibility of reaching such oxidizing potentials in aqueous electrolytes and at open circuit. This is done by mapping the quasi-Fermi levels of electrons and holes at the interfaces as a function of the light intensity. Nanostructured WO 3 photoelectrodes for this purpose were fabricated by thermal annealing of a tungstic acid solution on fluorine-doped tin oxide. Electrochemical measurements are conducted at open circuit and 400 nm LED light illumination in electrolytes containing fast (O 2 /H 2 O 2 ), slow (O 2 /H 2 O), and very oxidizing (NaIO 4 /NaIO 3 ) redox couples. Photovoltage values scale with the light intensity and with the built-in potential for each redox couple and reach values up to 0.61 V under 20 mW cm –2 illumination for the NaIO 4 electrolyte. This shows that the photoelectrodes behave like Schottky-type diodes whose maximum possible energy output is determined mainly by the built-in voltage of each junction. For slow redox couples, the quasi-Fermi level of the holes increases with light intensity due to hole accumulation at the WO 3 –liquid interface. For example, for the O 2 /H 2 O electrolyte, interfacial hole accumulation and removal occur on the 90–300 s time scale. For the fast hole acceptor H 2 O 2, on the other hand, the quasi-Fermi level of the photoholes is pinned to the electrochemical potential of the O 2 /H 2 O 2 couple. This limits the energy conversion efficiency of the electrode. Overall, these results reveal the influence of charge transfer thermodynamics and kinetics on the photovoltage of WO 3 . Furthermore, the work further establishes VK-SPV as a contactless method to observe the photovoltage, carrier dynamics, and quasi-Fermi levels of semiconductor-liquid junctions.