Plasma-assisted catalysis for ammonia synthesis in a dielectric barrier discharge reactor: key surface reaction steps and potential causes of low energy yield
Zhe Chen, Bruce E. Koel, Sankaran Sundaresan
Abstract
Abstract Ammonia synthesis experiments were carried out in a coaxial dielectric barrier discharge (DBD) reactor packed with several different supports and metal catalysts. There was a marked increase in the reaction rate, over that obtained in an empty DBD plasma reactor, upon introduction of a packed bed of γ -Al 2 O 3 , Ru/ γ -Al 2 O 3 , or SiO 2 particles. The difference in the reaction rates over γ -Al 2 O 3 and Ru/ γ -Al 2 O 3 was minimal. Complementary zero-dimensional plasma kinetic model analysis was also performed using inputs from experimental data. This kinetic analysis allowed for gas phase reactions, Eley–Rideal (E–R) reactions, and direct adsorption of radical species on the γ -Al 2 O 3 surface. On the metal surface, dissociative adsorption of N 2 and H 2 , and Langmuir – Hinshelwood reactions were also included. This analysis revealed that, under the conditions of our experiments, ammonia synthesis proceeds principally by the formation of reactive radicals in the gas phase, which then adsorb and participate in E–R reactions on both the metal and support material surfaces. This finding illustrates a challenge for substantially increasing the energy yield for plasma-assisted ammonia synthesis in typical DBD reactors containing packed catalyst beads.