Dissimilar unbeveled aluminum to steel butt joint achieved by laser-arc hybrid welding-brazing
Gaoyang Yu, Xiaoming Nie, Lize Li, Shuhai Chen, Yonglei Wang
Abstract
In this study, unbeveled butt joints of 2 mm thick steel and aluminum plates were welded using a laser-arc hybrid process. The influence of welding speed and wire feed speed on joint weld formation, microstructures, and mechanical properties were investigated. The results indicate that using a laser-arc hybrid heat source enables good weld formation of steel/aluminum dissimilar metals without groove preparation, even under high welding speed conditions. The steel side interface formed Fe₂(Al,Si)₅ near the steel and Fe(Al,Si)₃ near the aluminum. As the welding heat input decreased, the thickness of the intermetallic compounds gradually reduced. With an increase in welding speed or wire feed speed, the tensile strength of the joint first increased and then decreased, reaching a maximum of 104.47 MPa. Cracks propagated rapidly along the intermetallic compound region, resulting in brittle fracture characteristics. The three-point bending test showed a maximum longitudinal bending angle of 53.82° and a maximum transverse bending angle of 36.54°.