Evolution of Pore Structure and Fractal Characteristics in Transitional Shale Reservoirs: Case Study of Shanxi Formation, Eastern Ordos Basin

Abstract

The fractal dimension quantitatively describes the complexity of the shale pore structure and serves as a powerful tool for characterizing the evolution of shale reservoirs. Thermal simulation experiments were conducted on the low-maturity transitional shale from the Shanxi Formation in the Ordos Basin. The initial samples consisted mainly of quartz (39.9%) and clay minerals (49.9%) with moderate-to-good hydrocarbon generation potential. Samples from different thermal maturation stages were analyzed through geochemical, mineralogical, and pore structure experiments to reveal the evolution of mineral compositions and pore structure parameters. The fractal dimensions of the pore structure were calculated using both the FHH and capillary bundle models. Correlation coefficients and principal component analysis (PCA) were employed to explore the factors influencing the fractal dimension and its evolutionary patterns during reservoir development. The results indicate that (1) with increasing thermal maturity, the quartz content gradually increases while the contents of clay minerals, carbonate minerals, pyrite, and feldspar decrease. (2) The evolution of porosity follows five stages: a slow decrease (0.78 < Ro < 1.0%), a rapid increase (1.0% < Ro < 2.0%), a relatively stable phase (2.0% < Ro < 2.7%), a rapid rise (2.7% < Ro < 3.2%), and a slow decline (Ro > 3.2%). The evolution of the pore volume (PV) and specific surface area (SSA) indicates that the proportion of pores in the 5–20 nm and 20–60 nm ranges gradually increases while the proportion of pores smaller than 5 nm decreases. (3) The fractal dimension of shale pores (D1, average value 2.61) derived from the FHH model is higher than D2 (average value 2.56). This suggests that the roughness of pore surfaces is greater than the complexity of the internal pore structure at various maturities. The DM distribution range calculated from the capillary bundle model was broad (between 2.47 and 2.94), with an average value of 2.84, higher than D1 and D2. This likely indicates that larger pores have more complex structures. (4) D1 shows a strong correlation with porosity, PV, and SSA and can be used to reflect pore development. D2 correlates well with geochemical parameters (TOC, HI, etc.) and minerals prone to diagenetic alteration (carbonates, feldspar, and pyrite), making it useful for characterizing the changes in components consumed during pore structure evolution. (5) Based on the thermal maturation process of organic matter, mineral composition, diagenesis, and pore structure evolution, an evolutionary model of the fractal dimension for transitional shale was established.

Topics & Concepts