Improved Thin-Kerf Processing in Cf/SiC Composite by Waterjet-Guided Nanosecond Laser Decreases Oxidation and Thermal Effect
Jiayu Wang, Guangyi Zhang, Qiaoli Wang, Youmin Rong, Chaochao Zhao, Chunguang Chen, Binying Bao, Wenwu Zhang, Liyuan Sheng
Abstract
As a hard and brittle material, the processing of Cf/SiC ceramic matrix composites (CMCs) faces significant challenges, especially in the processing of small-sized shapes. To address this challenge, laser processing with gas-assisted nanosecond laser (GNL) and waterjet-guided nanosecond laser (WNL) modes were applied to fabricate thin kerfs in the Cf/SiC composite. The surface morphology, microstructure, and chemical composition of the processed Cf/SiC composite were investigated comparatively. The results revealed that the coupling of helium in the GNL mode laser processing could make full use of the laser energy, but resulted in spattering in the kerf margin and a recast layer in the kerf surface, accompanied by obvious oxidation, while the coupling of the waterjet in the WNL mode laser processing decreased the oxidation significantly and removed the remelting debris, which produced a clear and flat kerf surface. Due to the taper caused by laser energy dissipation, the single-path laser processing in the Cf/SiC composite had a limited depth. The maximum depth of the kerf prepared by single-path laser processing with the GNL mode was about 328 μm, while that with the WNL mode was about 302 μm. The multi-path laser processing with the GNL and WNL modes could fabricate a through kerf in the Cf/SiC composite, but the coupling medium obviously influenced the surface morphology and microstructure of the underlying region. The kerf surface prepared by the GNL mode had a varied surface morphology, which transited from the top layer, covered with oxide particles and some cracks, to the bottom layer, featured with micro-grooves and small oxides. The kerf surface prepared by the WNL mode had a consistently smooth and clean morphology featured with broken carbon fiber and residual SiC matrix. The slow laser energy dissipation and open environment in the GNL mode resulted in a bigger HAZ and relatively serious oxidation, which caused local phase transformation and microstructure degradation. The isolation condition and rapid cooling in the WNL mode decreased the HAZ and restrained the oxidation, almost keeping the original microstructure. The thicknesses of the HAZ in the GNL- and WNL-processed Cf/SiC composite were about 200 μm and 100 μm, respectively. The WNL-processed Cf/SiC composite had a lower oxidation and thermal damage surface, which is instructive for the processing of the Cf/SiC composite.