Multi-tree cut-to-length harvesting of short-rotation poplar plantations
Natascia Magagnotti, Raffaele Spinelli, Kalle Kärhä, Piotr S. Mederski
Abstract
Abstract Small tree size represents the main challenge when designing a cost-effective harvesting system for European short-rotation plantations. This challenge is further complicated by the need to obtain 4-m logs for high-end products, which rules out the possibility of deploying whole-tree chipping. Both challenges can be met through mass or multi-tree handling (MTH), which must begin at the time of felling and continue uninterrupted along the whole supply chain. The objective was to: (1) gauge the productivity and the cost of CTL harvesting applied to these plantations; (2) assess log yield and capacity to match dimensional specifications; (3) determine if MTH applied to CTL technology offers a real benefit compared with conventional single-tree handling. The authors conducted a time study using a block design with a two-machine cut-to-length harvesting system (i.e. harvester and forwarder) in single- and multi-tree handling operations on the clear cutting of a hybrid poplar plantation in Poland, as well as we manually measured the produced volumes of the study. Higher productivity (+ 8%) was achieved under the multi-stem handling mode. The MTH system proved capable of containing harvesting costs below € 15 per green ton, while fulfilling set timber quality requirements in terms of value recovery and log quality specifications. A new, software-based, MTH system is recommended to be used in short-rotation poplar plantation for logs and biomass harvesting. When the coppicing season is over, the system can be deployed for the conventional thinning operations.