A <i>Ka</i>-Band Pseudo-Doherty Load-Modulated Balanced Amplifier With Gain Flatness Enhancement Technique
Chenxi Zhao, Xinmeng Zhang, Xin Xie, Huihua Liu, Yiming Yu, Yunqiu Wu, Kai Kang
Abstract
A millimeter-wave (mm-wave) fully integrated pseudo-Doherty load-modulated balanced amplifier (PD-LMBA) with a gain flatness enhancement technique is demonstrated in this article. Unlike the conventional LMBA topology based on using two balanced amplifiers (BAs) in the class-AB/B condition and a control amplifier (CA) in the class-C condition, the CA is used as the main amplifier in the class-B condition and the BAs as the auxiliary amplifiers in the class-C condition in the proposed configuration. Therefore, the proposed architecture only needs to satisfy the load condition at saturation rather than in both saturation and power back-off (PBO) conditions. This design can more easily and flexibly achieve a large dynamic power range. Furthermore, a gain flatness enhancement technique based on a variable cross-coupled pair (VCCP) is proposed to improve AM–AM characteristics without decreasing efficiency. The proposed fully integrated PD-LMBA is fabricated in a commercial 65-nm CMOS process and occupies 1.1 mm <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$^2$</tex-math> </inline-formula> . Adopting continuous-wave testing, the amplifier is found to provide a peak gain of 25.5 dB with a 3-dB gain bandwidth from 24.3 to 28.2 GHz. At 27 GHz, a measured saturated output power ( <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$P_{\rm sat}$</tex-math> </inline-formula> ) of 22.2 dBm with a peak power added efficiency (PAE) of 30.4% and output 1-dB compression point power ( <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$\text{OP}_{1\,\text{dB}}$</tex-math> </inline-formula> ) of 20.1 dBm with 23.6% PAE are achieved. The measured PAE at 8-dB PBO from <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$P_{\rm sat}$</tex-math> </inline-formula> still reaches 15.0%. Without applying any predistortion technology, the prototype demonstrates an ultralow AM–AM distortion characteristic that is less than 0.6 dB in the linear region at 28 GHz. Modulated signal measurements are also performed at the center frequency of 27 GHz. The amplifier provides 13.2 dBm average output power ( <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$P_{\rm avg}$</tex-math> </inline-formula> ), 13.8% average PAE, <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$-26.3$</tex-math> </inline-formula> dBc adjacent channel leakage ratio (ACLR) and <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$-$</tex-math> </inline-formula> 25.9 dB EVM for a 100 MSym/s single-carrier 64-quadrature amplitude modulation (QAM) signal with a 7.1-dB peak-to-average-power ratio. For a 2.4-Gb/s (400 MSym/s) signal, also at a carrier frequency of 27 GHz, this proposed PD-LMBA still demonstrates 12.3-dBm <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$P_{\rm avg}$</tex-math> </inline-formula> and 11.9% average PAE with <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$-$</tex-math> </inline-formula> 25.5 dB rms EVM and <inline-formula xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink"> <tex-math notation="LaTeX">$-$</tex-math> </inline-formula> 25.7 dBc ACLR.