Importance of Interfacial Passivation in the High Efficiency of Sb<sub>2</sub>Se<sub>3</sub> Thin-Film Solar Cells: Numerical Evidence
Yuanjing Chen, Youyang Wang, Rui Wang, Xiaobo Hu, Jiahua Tao, Guoen Weng, Chunhu Zhao, Shaoqiang Chen, Z. Q. Zhu, Junhao Chu, Hidefumi Akiyama
Abstract
In this paper, we demonstrate numerical evidence that interfacial passivation in the Sb2Se3 solar cell forming the configuration of indium tin oxide (ITO)/SnO2/CdS/Sb2Se3/Au is beneficial for suppressing defects and obtaining cells with high efficiency. First, the effects of two types of defects including bulk defects in the Sb2Se3 absorber layer and interfacial defects at the CdS/Sb2Se3 interface on the performance of solar cells are studied, respectively. It is found that the effect of the bulk defects varied greatly in different magnitudes of defect density, whereas significant deterioration could be caused by the interfacial defect at relatively lower defect density. Then, the types of three actual defects named D1, D2, and D3 measured experimentally in the Sb2Se3 solar cells are analyzed by comparing the simulation and experimental results. It is found that the case D1 and D2 existing in the absorber layer while D3 located at the interface makes the simulation and experimental results the most consistent, in which the interfacial defect D3 contributes the most to the degradation of cell performance. Finally, a SnO2-free Sb2Se3 solar cell sample is simulated to evaluate the crucial interfacial passivation effect of the SnO2 layer. The results show that introducing a SnO2 layer is beneficial for the passivation of not only the interfacial defects but some unclear mechanisms such as deep-level defects which are hard to be measured in the present experiment. The numerical simulation results provide evidence proving the importance of interfacial passivation in actual fabrication processes to improve the performance of Sb2Se3 solar cells.