Microstructure and mechanical properties of laser powder bed fusion Ti-6Al-4V after HIP treatments with varied temperatures and cooling rates
Nicholas Derimow, Jake T. Benzing, Howie Joress, Austin McDannald, Ping Lu, Frank W. DelRio, Newell Moser, Matthew Connolly, Alec I. Saville, Orion L. Kafka, Chad Beamer, Ryan Fishel, Suchismita Sarker, C. P. Hadley, Nik Hrabe
Abstract
This work investigated non-standard HIP cycles for PBF-L Ti-6Al-4V and characterized microstructure and tensile properties to compare between material that originated from the same build. For 920 °C, faster cooling rates (100 °C/min, 2000 °C/min) were found to promote bi-lamellar α microstructure, while the 2000 °C/min cooling rate improved the strength. For HIP with lower temperature (800 °C, 200 MPa), coarsening was minimized resulting in strength improvement. The slow cooling rate (12 °C/min) showed the highest strength as faster rates increased the amount of orthorhombic martensite ( α ″ ). For HIP with higher temperature (1050 °C), the as-built crystallographic texture was reduced and equiaxed prior-β grain morphology resulted, leading to more isotropic tensile properties. However, the cooling rate (2000 °C/min) was not enough to prevent formation of grain boundary α, which reduced strength and elongation. Machine learning was carried out on the dataset via Principal Component Analysis (PCA) to reduce the dimensionality of the parameters and microstructural features. • The structure and properties of 10 HIP treatments were studied for PBF-L Ti-6Al-4V. • HIP at 800 ∘ C resulted in less α coarsening and superior tensile properties. • Cooling at 2000 ∘ C/min from 920 ∘ C resulted in a bi-lamellar α microstructure. • Cooling at 2000 ∘ C/min over the β -transus led to deleterious grain boundary α growth. • Principal component analysis was used to model the structure-properties relationships.