Multiobjective optimization of end milling parameters for enhanced machining performance on 42CrMo4 using machine learning and NSGA-III
Van-Hai Nguyen, Tien-Thinh Le, Anh-Tu Nguyen, Hoang Xuan Thinh, Nhu-Tung Nguyen
Abstract
The present study analyzes and optimizes machining characteristics, including feed rate (fz), depth of cut (ap), cutting speed (Vc), cutter-coated material (Mtc) and cutting-edge radius (rt), impacting on surface roughness (Ra), material removal rate (MRR) and tool wear (VB) of 42CrMo4 steel during dry end-milling. A total of 108 experimental runs were conducted, focusing on Ra, VB and MRR as response parameters. The nano TiAlN PVD-coated tool yielded better results for Ra and VB than did the TiCN/Al2O3 MT-CVD-coated tool. Then, Ra, VB and MRR optimization was carried out simultaneously using a Non-Dominated Sorting Genetic Algorithm III (NSGA-III) and Machine Learning (ML) models. Pareto solutions were found to offer a range of values for the three performance objectives: Ra (0.315–0.556 µm), VB (12.33–32.48 µm) and MRR (0.44–3.58 cm3/min). A quantitative performance score (Ps) ranking index was calculated to rank Pareto solutions for practical case studies. Validation experiments were subsequently performed to affirm that the optimal solution fell within a reasonable error range, with MAPE of 9.58% for Ra, 9.25% for VB and 13.39% for MRR. The validation results underscore the versatility of this approach, suggesting its applicability to a wide array of machining optimization challenges.