Carbon dioxide adsorption/desorption performance of single- and blended-amines-impregnated MCM-41 mesoporous silica in post-combustion carbon capture
Pailin Muchan, Chintana Saiwan, Manit Nithitanakul
Abstract
Abstract High-surface-area, hexagonal-structured mesoporous silica, MCM-41, was synthesized and wet impregnated with three different amines of 2-(ethylamino) ethanol (EAE), ethylenediamine (EDA), and tetraethylenepentamine (TEPA) for use as solid adsorbents in post-combustion CO2 capture application. The CO2 adsorption test was performed at 25°C and atmospheric pressure using 15/85 vol% of CO2/N2 at a 20-mL/minute flow rate. Desorption was carried out at 100°C under 20 mL/minute of N2 flow. The results show that the capacity and rate of CO2 adsorption obtained from all the amine-modified adsorbents were significantly increased with increasing amine loading due to carbamate formation. Desorption efficiency and heat duty for regeneration were also affected by the amount of amine loading. The more stable the carbamate produced, the higher the energy was required. They exhibited the highest adsorption–desorption performance at 60 wt% amines used for impregnation. Blended EAE/TEPA at different weight ratios at a total concentration at 60 wt% amines was impregnated on MCM-41 adsorbent. Sorbent impregnated with 50%/10% of EAE/TEPA showed the best performance of 4.25 mmolCO2/g at a high adsorption rate, a low heat duty of 12 kJ/mmolCO2 and with 9.4% reduction of regeneration efficiency after five repeated adsorption–desorption cycles.