Impact of neutron irradiation on hardening of baseline and advanced tungsten grades and its link to initial microstructure
Chao Yin, D. Terentyev, A. Dubinko, Tao Zhang, M. Wirtz, Steffen Antusch, Roumen Petrov, Thomas Pardoen
Abstract
Abstract Six tungsten grades were irradiated in the Belgian material test reactor (BR2) and characterized by Vickers hardness tests in order to investigate the irradiation-induced hardening. These tungsten grades included: Plansee (Austria) ITER specification tungsten, ALMT (Japan) ITER specification tungsten, two products from KIT (Germany) produced by powder injection molding (PIM) and strengthened by 1% TiC and 2% Y 2 O 3 dispersed particles, and rolled tungsten strengthened by 0.5% ZrC from ISSP (China). The materials were irradiated face-to-face at three temperatures equal to 600 °C, 1000 °C, and 1200 °C to the dose of ∼1 dpa. The Vickers hardness tests under 200 gf (HV0.2) were performed at room temperature. The Vickers hardness increases as the irradiation temperature increases from 600 to 1000 °C for all materials, except for the ZrC-reinforced tungsten, for which the increase of hardness does not depend on irradiation temperature. The irradiation-induced hardness decreases after irradiation at 1200 °C. This is a result of defect annealing enhanced by thermally activated diffusion. However, even at 1200 °C, the impact of neutron irradiation on the hardness increase remains significant; the hardness increases by ∼30 to 60% compared to the non-irradiated value. In the case of TiC-strengthened material, the irradiation hardening progressively raises with irradiation temperature, which cannot be explained by the accumulation of neutron irradiation defects solely.