Influences of Material Selection, Infill Ratio, and Layer Height in the 3D Printing Cavity Process on the Surface Roughness of Printed Patterns and Casted Products in Investment Casting
Thanh Tan Nguyen, Van Tron Tran, Pham Thi Hong Nga, Van–Thuc Nguyen, Van–Thuc Nguyen, Nguyễn Chí Thành, Hong Minh Nguyen Thi, Nguyen Vu Anh Duy, Duy Nguyễn Thành, Văn Thành Nguyễn, Văn Thành Nguyễn
Abstract
As 3D-printed (3DP) patterns are solid and durable, they can be used to create thin wall castings, which is complicated with wax patterns because of the wax's fragility and high shrinkage ratio. According to this study's experiment results, polylactic acid (PLA), polyvinyl butyral (PVB), and castable wax (CW) are suitable materials for preparing investment casting (IC) cavities. The results indicate that the casting product with the highest-quality surface is obtained using a cavity prepared using a CW-printed pattern. PLA- and PVB-printed patterns provide a good surface finish for casted products. In addition, the roughness of both the printed and casted surfaces increases as the printing layer height increases. The roughness of the casted surface varies from 2.25 μm to 29.17 μm. This investigation also considers the correlation between the infill ratio and mechanical properties of PLA-printed patterns. An increase in the infill ratios from 0% to 100% leads to a significant increase in the tensile properties of the PLA-printed pattern. The obtained results can be practically used.