Humic acid attachment on chitosan-modified silica gel as an economical, efficient, and selective adsorbent for thorium and uranium removal
Erik Prasetyo, Kazuhiro Toyoda
Abstract
A novel, low-cost adsorbent material was prepared by the immobilization of humic acid on a silica gel surface coated with cross-linked chitosan (SiChiHA). The adsorbent was developed to remove selectively of Th(IV) and U(VI) from aqueous solution, including their pre-concentration and separation from lanthanides and high salinity conditions. A simple waste-less humic acid immobilization method was shown to be successful based on FT-IR, SEM-EDS, and zeta potential characterization results. The adsorbent was found to be stable over a wide pH range, with the highest capacities obtained at pH 3.5 (Th(IV)) and pH 5 (U(VI)). Langmuir model calculations yielded a maximum capacity of 30.6 mg g−1 and 75.4 mg g−1 for Th(IV) and U(VI). The adsorption process was found to be rapid (half concentration was removed within 10 min) and best described by a pseudo-second order rate equation. Increasing NaCl concentration up to 2 mol L−1 or lanthanide concentration up to 100 times did not significantly affect the removal efficiency for either Th(IV) of U(VI). Both elements could be sequentially separated by elution with ammonium citrate and nitric acid, respectively. The adsorption-desorption experiment showed that the adsorbent could be used for at least five cycles without significant capacity loss. This study provides insight into the development of low-cost adsorbent with practical functionality, including separation and regeneration ability, the advantageous properties scarcely reported in low-cost adsorbent literature.