Comparison of Dentinal Tubule Penetration between a Calcium Silicate-Based Sealer with Ultrasonic Activation and an Epoxy Resin-Based Sealer: A Study Using Confocal Laser Scanning Microscopy
Dani Song, Sung-Eun Yang
Abstract
OBJECTIVE: The aim of this study was to compare the degree of dentinal penetration between an epoxy resin-based sealer applied by using two different filling methods and an ultrasonically activated calcium silicate-based sealer via confocal laser scanning microscopy (CLSM). MATERIALS AND METHODS: Forty-five extracted permanent maxillary premolars with type II canals (Vertucci's classification) were subjected to the experiment. The root canals were instrumented and distributed randomly into the following three groups: AH Plus + continuous wave technique (AHC group); AH Plus + single cone technique (AHS group); and Endoseal MTA + single cone technique with ultrasonic activation (EMS) group. Each sealer was labeled with rhodamine B dye to allow visualization under CLSM. The sealer penetration depth in each sample was observed at 2 mm and 5 mm from the apex by using CLSM. The data were statistically analyzed by using analysis of variance or Kruskal-Wallis H test according to normality of variable (α = 0.05). RESULTS: = 0.02). At the 2-mm level, there were no statistically significant differences among any of the groups. The AHC group showed higher values than the other groups, but there was no statistically significant difference in the apical area where access of instruments was difficult. CONCLUSION: The AHC group showed the highest dentinal tubule penetration, but had questionable filing efficacy in the apical area, which is of particular importance for the success of root canal treatment. Therefore, in areas such as the apical 2 mm of premolars with type II canals, which are difficult to access by using instruments such as heat carriers, other appropriate approaches may be required accordingly.